Change search
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf
Fabrication, spark plasma consolidation, and thermoelectric evaluation of nanostructured CoSb3
Stockholm University, Faculty of Science, Department of Materials and Environmental Chemistry (MMK).
Show others and affiliations
2014 (English)In: Journal of Alloys and Compounds, ISSN 0925-8388, E-ISSN 1873-4669, Vol. 612, 293-300 p.Article in journal (Refereed) Published
Abstract [en]

Nanostructured powders of thermoelectric (TE) CoSb3 compounds were synthesized using a chemical alloying method. This method involved co-precipitation of oxalate precursors in aqueous solution with controlled pH, followed by thermochemical treatments including calcination and reduction to produce stoichiometric nanostructured CoSb3. Moreover, CoSb3 nanoparticles were consolidated by spark plasma sintering (SPS) with a very brief processing time. Very high compaction densities (>95%) were achieved and the grain growth was almost negligible during consolidation. An iterative procedure was developed to maintain pre-consolidation particle size and to compensate Sb evaporation during reduction. Significant changes in particle size and morphology were observed, and the post-reduction cooling was found to be an important stage in the process. The spark plasma sintering (SPS) parameters were optimized to minimize the grain growth while achieving sufficient densification. Grain sizes in the range of 500 nm to 1 mu m, with compaction density of 95-98% were obtained. Preliminary measurements of thermal diffusivity and conductivity showed the dependence on grain size as well as on porosity. TE transport properties were measured in the temperature range of 300-650 K. Sample showed p-type behavior with a positive Seebeck coefficient, which increases with increasing temperature. Electrical conductivity measurements indicate metallic behavior and it decreases with increasing temperature. Thermal conductivity also decreases with increasing temperature and major contribution is due to the lattice component. A TE figure of merit of 0.15 was achieved for high purity CoSb3 nanostructured TE material at 650 K and these results are comparable with the values reported for the best unfilled/undoped CoSb3 in the literature.

Place, publisher, year, edition, pages
2014. Vol. 612, 293-300 p.
Keyword [en]
Nanostructured, CoSb3 skutterudites TE, Spark plasma sintering
National Category
Chemical Sciences
Identifiers
URN: urn:nbn:se:su:diva-107083DOI: 10.1016/j.jallcom.2014.05.119ISI: 000339692300047OAI: oai:DiVA.org:su-107083DiVA: diva2:744225
Note

AuthorCount:7;

Available from: 2014-09-07 Created: 2014-09-03 Last updated: 2017-12-05Bibliographically approved

Open Access in DiVA

No full text

Other links

Publisher's full text

Search in DiVA

By author/editor
Johnsson, Mats
By organisation
Department of Materials and Environmental Chemistry (MMK)
In the same journal
Journal of Alloys and Compounds
Chemical Sciences

Search outside of DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetric score

doi
urn-nbn
Total: 28 hits
CiteExportLink to record
Permanent link

Direct link
Cite
Citation style
  • apa
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Other style
More styles
Language
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Other locale
More languages
Output format
  • html
  • text
  • asciidoc
  • rtf